HP Color LaserJet 4600 and 5500 Series Printers - 49.xxxx Errors

 TROUBLESHOOTING STEPS

The printer shows a 49.XXXX blunder on the control board. 49.XXXX mistakes, including 49.FF04 , 49.FF07 ,49.FF08 , and 49.FF09 could be equipment or programming blunders. The blunder could be caused by outsider memory, dishonorably introduced or outsider EIO gadgets or a particular print work and additionally programming application. 

Decide whether the mistake is programming or equipment by resending any occupations in advance, sending an alternate employment from another product application, or changing the measure of the present place of employment. On the off chance that the blunder is as yet give different applications or occupations, proceed with the investigating ventures in the following area. Not Resolved Your Error, Please Contact +1-855-517-2433

Hp Printer | Call Now +1-855-517-2433

TROUBLESHOOTING STEPS

1 Verify that the formatter light is flickering or unfaltering. On the off chance that the formatter is squinting, it is working legitimately and most likely does not should be supplanted. On the off chance that the formatter light isn't squinting, continue to Step 2. 

2 Turn off the printer and unplug the power line. 

3 Remove the HP Jetdirect card, outsider gadget, hard plate, parallel link, or IFR link from the formatter in the event that one is introduced. 

4If the mistake proceeds with frill expelled from the formatter, play out a cool reset on the printer. Guarantee the HP Jetdirect card isn't in the printer amid a chilly reset or the card settings will be changed back to default settings. To play out a chilly reset, do the accompanying: Not Resolved Your Error, Please Contact +1-855-517-2433

• Turn on the printer. 

• Watch the control board. 

• At the point when the memory begins checking, press and hold the green (Select ) catch.

• Keep holding the green check catch until the Ready, Data, and Attention lights streak once, and afterward remain on relentless. 

• Discharge the check catch when the Ready, Data, and Attention light are on consistent. 

• The control board will show SELECT LANGUAGE . 

• Press (Down Arrow ) catch once. The control board will show COLD RESET . 

• Press (Select ). The printer will play out a cool reset and afterward proceed with its energy on arrangement. 

5 In the event that the printer comes up to prepared, print a Configuration page. On the off chance that a 49 mistake happens from printing inner pages, proceed to the subsequent stage. 

6 Kill the printer and unplug the power string. 

7 Evacuate the eight screws around the formatter. 

8 Evacuate the formatter. See Figure 1. 

9 Reseat the firmware and memory modules on the formatter. Check for any DIMMs that are non-HP and evacuate them. Non-HP DIMMs are not upheld by HP and may cause this mistake. Supplant with HP DIMMs, if fundamental. 

10 Reseat the girl (interconnect) board. The little girl board is associated with the formatter behind EIO opening #1. To discharge the girl board, push operating at a profit holding tab underneath the formatter (see Figure 1, get out 1), at that point lift up the one side of the little girl board.

Read More...

If The Above Solution Has Not Resolved Your Error, Please Contact +1-855-517-2433